Lamp for UV/LED nails, hybrid varnishes, gels, acrylic gels 258W

✔ Lamp for hybrid manicure and pedicure, dedicated to curing hybrid varnishes, gels and acryllogels.
✔ The lamp has up to 4 working modes for 10, 30 and 60 seconds and additionally a mode Low Heat Mode allowing gradual heating of the lamp, helpful when curing builder gels.
✔ Thanks to the foldable handle and the lightweight and compact design, you can carry the lamp easily and conveniently.

PERTIES AND BENEFITS

✔ 72 evenly spaced diodes eliminate the risk of dead zones’ curing.
✔ Low Heat Mode allows the lamp to heat up gradually especially useful when working with sensitive plates and builder gels.
✔ Motion sensor to start the lamp automatically.
✔ Foldable handle for easy carrying.
✔ Large electronic display with timer.
✔ Removable bottom for easy pedicure.
✔ Special compartment ideal for placing your phone.
✔ Combination of white and red light emission.

HOW TO USE

1. Connect the unit to the power supply.
2. Switch on the lamp using the timer button – you can select one of the available timer options of 10s/20s/60s/99s (99s to Low Heat Mode), or start without selecting a time.
3. Insert your hand into the lamp and illumination will start automatically when movement is detected by the sensor (illumination limit is 99s).
4. Look at the display to control the CURING TIME.
5. Follow the curing instructions for the selected product.
6. When not using the lamp, remember to always switch off the power cord from the socket.

TECHNICAL DATA

• Maximum power: 258 W
✔ Number of LEDs: 72
✔ Input voltage: 100-240V 50/60Hz
✔ Wave range: 365+405nm
✔ Cable length: about. 143cm
✔ Width: approx. 22 cm
✔ Height:about. 10 cm
✔ Depth: approx. 15 cm

Safety of use

❇ Before use, read the operating instructions carefully.
❇ Remember that the actual voltage used must match the parameters of the lamp.
❇ Protect the unit from contact with dust, water and other liquids.
❇ Wipe with a mild detergent if the surface is dirty. Do this when the unit is switched off (unplug the power cord).
❇ Do not use the lamp in a humid /wet space and when humidity levels reach high values.
❇ Do not use the lamp if the power cord or timer buttons are damaged.
❇ Remember that the unit should not be left running for more than 60 minutes as this may reduce the life of the unit. The unit is intended for indoor use.
❇ Remember that making independent switches and changes to the unit is prohibited and equivalent to voiding the warranty, and the manufacturer assumes no responsibility for the correct and safe operation of the unit.
❇ Never stare directly into the UV light, which can cause damage to the eyes. The lamp uses UV/LEDs, which emit dangerous UV rays. These can also cause damage to the skin. Your skin may be more sensitive to UV rays when you are taking medication or using cosmetics. If you notice sudden changes on your skin, seek medical advice immediately.
❇ Keep out of reach of children.